SEALER S-1
SEALER S-1
SEALER S-1 a sophisticated Liquid with the appearance and viscosity of water , used to reduce the absorption of marble, granite, terrazzo tiles, Sesame tiles , stone, silicate, chipped stone, concrete, and more.
After applying SEALER S-1 ,it merges with the surface, reduces its absorption , and reduces the exposure of the surface to stains . SEALER S-1 is transparent and dosn't affect visually the appearance of the surface implemented, ie. after applying the sealer, the surface will look as it did before application.
The sealer can be used on: Marble, granite, stone, silicate, sawn stone, terra cotta, concrete, plaster, cement, concrete blocks, porcelain tiles, and more.
Benefits:
-
Reduces EFFLORESCENCE effects (calcium hydrogen "rash" ).
-
increases the resistance of the stone to friction.
-
reduces potential stains.
-
Resistant to all weather conditions over time.
-
Nonflammable.
-
Easy to apply - odorless & colorless.
-
Environmentally and user friendly.
Before applying :
the surface must be clean and dry. Possible to clean the area using AMDI or AMD6 (depending on surface).
Directions for use :
The material can be applied by brush, sponging or spraying according to the user's convenience. After application wait 15-30 minutes and then carefully wipe the surface with a cloth until complete drying. This is very important!
Allow the surface to dry for 24 hours after application, before exposure to moisture.
Do not apply the material if the surface temperature is less than 7 degrees or higher than 30 degrees. Therefore it is not recommended to apply the material in an external application afternoon, but in the early morning. Note: leftovers after application should be wiped from the surface thoroughly before drying. If not, a white residue will be created on the surface - which can be removed easily by scrubbing with a Scotch/steel wool.
Sealing joints (grout) must be done at least 72 hours after applying the grout.
Sealing of concrete surfaces, projection, etc. Only after the completion of the surface's "Healing" ( ashpara ) . While applying the material on walls, make sure to protect aluminum and glass. Prolonged contact of the sealer with these two substances may cause them harm since the material contains alkaline. Most surfaces require one "layer". Very Porosive Surfaces may require additional layers.
Average coverage of 1 Liter is of about 15 square meters pending on surface's absorption.
Precautions:
material is alkali strong, Wear protective gloves and goggles and avoid exposing to skin & eyes during use.
In case of contact with skin or eyes, wash with plenty of water.
If applying by spray make sure to protect breathing tunnels with a face mask.
In Any case before applying the material, test it in a hidden corner, to make sure results are as expected